Forums Forums Classes Warlocks Affliction 8.0.x Cyms 8.0.x Afflicym ST/Boss based

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
  • DirtForSale
    Post count: 932

    Thought i would throw in my old way of doing macros due to the GCD changes as i think they fit better than the fast spamming way. This macro seems to work well for me and will re-apply all the dots.

    I am not using Drain Soul or Vile Taint in this one.

    It will use Shadow Bolt, Siphon Life, Corruption, Deathbolt, Phantom Singularity, Darkglare and Haunt
    If the macro is used correctly, it will always re-apply dots before they expire and will always have max dots up for Darkglare and Deathbolt.

    This is a tap and wait macro. This is not for fast spam, it will not net you the highest dps by spamming fast.
    If you must use a MS setting you’d need around 1650ms or 1.650 on Synapse for it to work and even then you might need to pause now and again.


    Talents 3312322

    This macro contains 1 macro version. This Sequence was exported from GSE 2.3.01.

    Macro Version 1

    Step Function: Sequential

    KeyPress: Summon Felhunter

    Main Sequence: Corruption, Unstable Affliction, Summon Darkglare, Shadow Bolt, Agony, Siphon Life, Phantom Singularity, Deathbolt, Haunt

    Gary Bingham
    Post count: 7

    About to run all LFR antorus bosses with this at 1650 wait time and 50 ms key press time. 228 ilvl with over 90% mastery, over 20% crit about 15% haste almost 1.3k int. I will edit this post with DPS as i kill bosses

    Tabby Post
    Post count: 2

    Hi i had a question, for questing. i was trying to replace shadow bolt with drain life. but its not letting me edit it out. 🙁

    Post count: 932

    Should allow edits, they are not locked down at all.

    I don’t know if this would be the best build to go out into the world, it’s more an ST boss killer build. I wouldn’t take it into Dungeons myself

    Senior Sergeant
    Post count: 46

    I sim at 2.8k, but only getting 1.7k. I figure 2.2-2.6 should be reasonable to account for single macro use and margin of error. I’m must be doing something wrong, but I’m not sure what. I’m manually pressing. I get periods of clipping dots way too soon or by periods of dots falling off for a few seconds. I press my key, wait for the cast bar and press again and continue that process unless it’s during the part of the sequence with the insta cast dots, which I then press right after the GCD. Any advice?

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.